2n M2M Solution 2N SmartCom - User Manual 1.9.0 Uživatelský manuál Strana 17

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 149
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 16
172N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2.
Figure: SIM Card Installation
Insert the SIM card in the holder.
Push the card in until it clicks into position.
Caution
Make sure that the GSM provider's SIM card is intended for the GSM
network supported by your version and that2N SmartCOM
®
GPRS–based data transmission is activated.
Make sure that the SIM card does not request the PIN or that the PIN
is identical with that set in the configuration.2N SmartCOM
®
Remember to set the relevant SIM and provider's services (call
forwarding, call barring, preferred networks, SMS centre, etc.) on your
mobile phone ( ) before inserting the SIM card in 2N MeterModem
®
2N SmartCOM.
®
Power Supply
2N SmartCOM
®
is DC supplied from a 12V/0.5A power adapter. Make sure that the
voltage value and polarity comply with the data specified at the powe2N SmartCOM
®
r connector before connecting your to an adapter other than that2N SmartCOM
®
included in the delivery.
is DC supplied in the range of 5–50V. Make sure that the2N SmartCOM PRO
®
voltage value and polarity comply with the data specified at the powe2N SmartCOM
®
r connector before connecting your to an adapter other than that2N SmartCOM
®
included in the delivery. Connect the supply voltage to the 4–pin connector next to the
RS232 connector. You can also connect there a gel–lead–acid accumulator as a power
supply backup. The supply voltage is also present on the 10–pin input circuit terminal
block on the opposite side of the device. These contacts can be used as auxiliary, e.g.
for connecting supply voltage to relays.
Zobrazit stránku 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 148 149

Komentáře k této Příručce

Žádné komentáře