2n M2M Solution 2N SmartCom - User Manual 1.9.0 Uživatelský manuál stáhnout pdf (Strana 111)

1112N TELEKOMUNIKACE a.s., www.2n.cz

Enter the command to enable/disable the use of the http interface: 0 – disabled,

1 – enabled.

at^sccfg="at_port",1562

Enter the command to set the AT API port to 1562.

at^sccfg="server_restart"

Enter the command to restart the Server.2N SmartCOM

Caution

All the above parameters are saved into the server database but will

not become effective until the new database is loaded into the server

memory after restart.

Terminal Connection

atd<ser_no>#<port>

Enter the command to establish connection to the selected terminal and selected

port.

Note

Suppose you want to establish connection to terminal 50–0295–0562

and its RS 232 port. Enter the following command into the API:

ATD5002950562#1

+++

Enter the command to switch on the command mode for you to enter the basic

AT commands for server information and the command for connectionATH

termination.

ato

Enter the command to switch back to the data mode.

ath

Enter the command to terminate connection with the currently connected

terminal without leaving the API environment. You can go on entering commands

and establish new connections.

Terminal Communication

at^scstate<ser_no>

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 148 149

Žádné komentáře

2n M2M Solution 2N SmartCom - User Manual 1.9.0 Uživatelský manuál Strana 111