2n Helios IP Automation v2.5 Uživatelský manuál stáhnout pdf (Strana 6)

62N TELEKOMUNIKACE a.s., www.2n.cz

The figure above shows a typical interconnection of the Event, Action and Condition

blocks. It holds true in general that an action is always tied with a selected event and is

executed when a selected condition is met. The condition is optional and if none is

selected, the action is executed whenever the assigned event occurs. 2N Helios IP

defines a number of events, actions and conditions to be further set.Automation

Refer to the subsections below for the full list.

The example shown in the figure above can be interpreted as follows: The SetOutput

action (digital output setting) is executed if the event (logic input1InputChanged

change from log.0 to log. 1) arises and the (active profile 1) condition is met.Profile

The web interface helps you configure block combinations2N Helios IP

(Automation) easily. The configuration shown in the figure below corresponds to the

example above.

1 2 3 4 5 6 7 8 9 10 11 ... 32 33

Žádné komentáře

2n Helios IP Automation v2.5 Uživatelský manuál Strana 6