2n Analogue UMTS gateway 2N SmartGate UMTS - Manual, Uživatelský manuál stáhnout pdf (Strana 43)

Table of Parameters

3.2

Off-Hook FXS line and dial PASSWORD plus to activate the function again.

Setting options: 0-8 characters (0-9)

Default setting: blank

Operator for Integra Function No.: 405

In some UMTS/GSM networks you can add to dialed number # character and

PBX subscriber number. Subscriber number is displayed on other side together

with CLI. This parameter take place when dialed number doesn't contain #

character. Common parameter for both FXO and FXS port.

Setting options: 0-8 characters (0-9)

Default setting: blank

DTMF code for On-Hook Function No.: 409

Using this code, you can terminate call to UMTS/GSM network, if busy tone

detection on 2N® SmartGate UMTS fails, or if connected equipment doesn't

transmit busy tone.

Setting options: 0-8 characters (0-9,*,#)

Default setting: blank

Caution

n Configuration using phone line programming (DTMF) is applicable for line

‘Other prefixes’ only.

Prefix Function No.: -

Dialed number prefix identifying the call type. "Other numbers" line is used for

calls with prefixes that are not included in the table.

Setting options: 0-16 characters (0-9,*,#)

Default setting: blank

Call enable Function No.: 491

This parameter allows/bars calls with corresponding prefixes.

Setting options: YES(1)/NO(0)

Default setting: YES

Number length Function No.: 493

The parameter defines the expected length of dialed number. It enables to start

dialing into UMTS/GSM or FXO interface immediately after the last digit is dialed.

If the telephone number to be dialed is shorter, a timeout is respected. The "0"

setting means that the function is disabled.

Setting options: 0, 3-15

Setting step: 1

Default setting: 0

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 82 83

Žádné komentáře

2n Analogue UMTS gateway 2N SmartGate UMTS - Manual, Uživatelský manuál Strana 43